Electronics

STEP 1: Remove the mounting plate from the control box

STEP 2: Decide the layout of the electronics on the mounting board

Note: The 12V battery is not shown in the video below. Remember to leave space near the Mean Well for the battery.

STEP 3: Assemble and connect the electronics as per the following wiring video

Wiring

Do not plug the AC cable into the wall mains AC outlet during the build and assembly process.

Note: MicroSD card to be inserted in Raspberry Pi after PANOPTES software installation is not shown in the video above.

AC OK & Bat OK

AC Mains

Battery

Tips to secure different electronic components

Using Cable Ties and Standoffs

Arduino & Power Distribution Board

DC-DC Converter

Raspberry Pi & GrovePi+