📘
PANOPTES User Guide
  • PANOPTES User Guide
  • FAQ
  • Building
    • Getting Started
      • Building Overview
      • Safety Guide
      • Parts Listing
    • Hardware Build
      • Camera Box
        • Camera Setup
        • Electronics
        • Hardware and Assembly
        • 4 Camera Design
      • Control Box
        • Electronics
        • Hardware and Assembly
      • Power and Network
        • Network Setup
        • Host Site (Mains) Power
        • UPS and Battery Backup
        • Power Distribution
      • Mount and Pier
        • Pier
          • Fabrication
          • Assembly
        • Mount
          • Assembly
          • Saddle Plate Rotation
          • Balancing
    • Software
      • Installing OS
      • Installing POCS
        • PANOPTES Unit Install
        • Developer Install
      • Arduino - Power Distribution
  • Deploying
    • Deployment Guide
      • Site Planning
      • Camera Focus
      • Polar Alignment
        • Overview
        • Drift Method
        • Procedure
          • Find Misalignment
          • Fix Misalignment
  • Running
    • Operating Guides
      • Automated Operation
      • Manual Operation
Powered by GitBook

Links:

  • Website
  • Forum
  • Software

2023 Project PANOPTES

On this page
  • STEP 1: Set up the camera electronics
  • STEP 2: Remove the mounting plate from the camera box
  • STEP 3: Decide the layout of the electronics on the mounting board
  • STEP 4: Assemble and connect the electronics as per the following wiring video
  • Tips to secure different electronic components

Was this helpful?

  1. Building
  2. Hardware Build
  3. Camera Box

Electronics

PreviousCamera SetupNextHardware and Assembly

Last updated 2 years ago

Was this helpful?

STEP 1: Set up the camera electronics

STEP 2: Remove the mounting plate from the camera box

STEP 3: Decide the layout of the electronics on the mounting board

STEP 4: Assemble and connect the electronics as per the following wiring video

Tips to secure different electronic components

The MicroSD card will later be installed with Ubuntu and the PANOPTES software (POCS). Make sure the MicroSD card is accessible and easy to take out while securing the Raspberry Pi.